live loading washer sizing basics 기술 가이드

Why sizing from diameter alone is not enough

Two joints with the same bolt size may need very different spring packs. One may need only a modest preload reserve, while another must absorb significant settlement or thermal movement without losing sealing force.

That is why live loading washer sizing has to follow the joint behavior, not the hardware dimensions alone.

The core inputs in a sizing review

The key inputs are target clamp load, expected movement, available stack height, service temperature and environmental severity. Once those are known, the stack can be judged on spring rate and travel, not only on nominal part size.

This is especially important in flange and valve systems where the sealing window is narrow.

• Bolt size and available installation envelope.
• Required preload or packing stress window.
• Expected gasket or packing settlement.
• Temperature cycle and corrosion exposure.

Where sizing mistakes usually happen

Mistakes often come from oversimplifying the problem: copying a prior washer size, ignoring available travel or specifying a stack that is too stiff to compensate meaningfully in service.

That can leave the customer with a spring pack that looks correct dimensionally but fails to stabilize the joint.

What makes RFQ review faster

If buyers provide bolt size, sealing duty, target load and operating temperature up front, live loading sizing can move faster with fewer revision rounds.

That is usually enough for FeTech to tell whether the job can use a standard series or needs a more application-specific stack.